Zak062's alltrac ***CS HOOD*** BIG 2 POST UPDATE 11-9-09

So its about time i made a ride page.

A little history about my car. I got it from a guy in chicago, near skokie. I paid 2k for it with 180k on the dash. I was told the engine had a FULL rebuild and a newer supra turbo. Now when i took out the engine the seals still had a bright red to them so i wouldn't doubt the rebuild. I had the car for about a month before the clutch started slipping. I garaged her and it took me 2 months to pull the engine and replace my clutch. Considering that was my FIRST engine pull, i did damn good. It took me another month to get the correct parts and put her back in. You guys wouldn't believe what i had to do to get a damn flywheel. Its been 3 months since and im loving every second of her.

Here are some pictures of her.

'

 

here is when i had to replace the clutch








Pretty soon here im gonna get myself a Daily driver and garage her again. This time to build the engine and to strip her down.

 

NEW GAUGE POD!!!!!!!!!!!

 

Okay so here go my plans for the alltrac.

[x]Step 1
[x]Get a daily driver


[x]Step 2
[x]Pull engine
[x]Strip interior
[x]Strip exterior
[x]Strip engine bay


[x]Step 3
[x]Disassemble engine
[x]Remove sound dedining material
[x]Sand interior
[x]Primer interior


[ ]Step 4
[ ]Sand exterior
[ ]POR 15 undercarriage & common rust areas
[ ]Primer exterior and POR 15 areas


[ ]Step 5
[ ]Build Engine
-[ ]Block (with rods and bearings) http://www.atsracing.net/strokershortblock.htm
-[ ]Head gasket http://www.atsracing.net/toyota_team_eu ... dgaske.htm
-[x]Throttle body inlet http://www.atsracing.net/ats_racing_thr ... _inlet.htm
-[x]EGR block off plates http://www.speed-source.net/products/3SGTE_2JZ.htm
-[ ]Head studs https://935motorsports.com/catalog/prod ... cts_id=714
-[ ]Oil pump (any ideas?)
-[ ]Main studs https://935motorsports.com/catalog/prod ... cts_id=924

[ ]Buld head
-[ ]Valves (any ideas?)
-[ ]Valve springs http://www.atsracing.net/valve_springs.htm
-[ ]Cams 272? http://www.atsracing.net/cams.htm
-[ ]Cam Gears http://www.atsracing.net/atscamgears.htm
-[ ]Fuel rail http://www.speed-source.net/products/3s ... l_rail.htm
-[ ]Fuel pump+regulator http://www.speed-source.net/products/fuel_regulator.htm
-[ ]Remove tvis http://www.atsracing.net/phenolicspacer.htm
-[x]Valve cover bolts http://www.twosrus.com/catalog/product_ ... ucts_id=76

[ ]Drivetrain mods
-[x]slave cylinder pushrod http://www.speed-source.net/products/pushrod.htm
-[ ]Shift cable bushings http://www.speed-source.net/products/shifter_cable.htm
-[ ]Shift base bushings http://www.speed-source.net/products/shifter_base.htm
-[ ]Clutch hose http://www.speed-source.net/products/clutch_hoses.htm
-[ ]Flywheel bolts https://935motorsports.com/catalog/prod ... ts_id=1337
-[ ]Flywheel http://www.twosrus.com/catalog/product_ ... ucts_id=41
-[ ]Clutch (any ideas?)
-[ ]Shifter http://www.twmperformance.com/shortshif ... ifters.htm

[ ]Suspension mods
-[x]Polyerthan mounts http://www.speed-source.net/products/polymount.htm
-[ ]Crossmember busings http://www.speed-source.net/products/crossmember.htm
-[ ]Rear strut bar https://935motorsports.com/catalog/prod ... cts_id=356
-[ ]Front strut bar https://935motorsports.com/catalog/prod ... cts_id=355
-[ ]Front control arm bushings https://935motorsports.com/catalog/prod ... cts_id=804
-[ ]Rear control arm bushings https://935motorsports.com/catalog/prod ... cts_id=805
-[ ]Front inner control arm bushings https://935motorsports.com/catalog/prod ... ts_id=1000
-[ ]Rear inner control arm bushings https://935motorsports.com/catalog/prod ... ts_id=1001
-[ ]Rear trailing arm bushings https://935motorsports.com/catalog/prod ... cts_id=374
-[ ]Outter rear trailing arm bushings https://935motorsports.com/catalog/prod ... 374♦
-[ ]Front sway bar https://935motorsports.com/catalog/prod ... cts_id=370
-[ ]Rear sway bar https://935motorsports.com/catalog/prod ... cts_id=372
-[ ]Front struts https://935motorsports.com/catalog/prod ... cts_id=221
-[ ]Rear struts https://935motorsports.com/catalog/prod ... cts_id=729
-[X]Springs (Intrax) thanks 2of81 ----$125

[ ]Exhaust mods
-[ ]Downpipe http://www.ssautochrome.com/level.itml/icOid/1593
-[ ]Custom 3" exhaust
-[ ]Port exhaust manifold

[ ]Cooling mods
-[x]intercooler kit http://www.ssautochrome.com/level.itml/icOid/1438
-[ ]Radiator (any ideas?)
-[ ]Radiator hoses https://935motorsports.com/catalog/prod ... cts_id=295
-[ ]Upgraded oil cooler???
-[x]Fans http://www.twosrus.com/catalog/product_ ... ucts_id=96

[ ]Electronics
-[ ]Oil pressure guage
-[ ]Electronic boost controller
-[ ]Oil temp guage
-[ ]A-pillar 3 guage pod http://www.gaugepods.com/
-[ ]02 sensor guage
-[ ]Fuel pressure guage
-[ ]Hydra Nemisis EMS http://www.koracing.net/viewproduct.php ... roduct=101

[ ]Turbo
-[ ]obtain cheap ct26(st185) with mainfold

[ ]Misc... mods
-[ ]Catch can https://935motorsports.com/catalog/prod ... cts_id=924
-[x]Custom 3" straight intake
-[x]BOV
-[x]Relocate battery


[ ]Step 6
[x]Put engine back in
[ ]Get car painted by reputable shop


[ ]Step 7
[ ]Break engine in
[ ]New turbo http://www.koracing.net/viewproduct.php ... roduct=222


[ ]Step 8
[ ]pwn teh noobz!

Feedback is greatly appriciated

 

lol, definatly gonna document it more than mafix did for nemisis.

 

I have obtained a daily driver, woot woot!!!!!!! I'll be picking it up thursday but i got to wait till i get the money to renew her plates because this is cleaning me out.


I got her for 1k

 

nah, i keep forgeting to take that out of my sig. Thats been gone for a long time

 

picked her up today, theres not a mechanical thing wrong with her. Drove her 2 hours home fine, all power options, sun roof, auto climate control, the only thing shes missing is the all-trac.

 

UPDATE 10/1/07

So i have proof that god hates me....

you wouldn't believe how loud the thuds where everytime i shifted.

But you know what, its okay because this gave me an excuse to go have some fun. Battery is now in the rear. Everything is hooked up, just gotta fix the mount first before everything goes back together. O and i gotta weld a few nipples onto the new intake tube for the PCV.




I also went and bought some intrax springs(thx 2of81). I cant wait to put those on .


comments welcome and appriciated

 

yea man, i am. Im just really... really short on money now. My gt-s's engine blew on me... 3 hours from home. Im going back there this tuesday to tow her back up here... Then it will be time for a rebuild of her engine.. then my alltrac gets attention.

 

the red celica is home, yay! now the fun begins

 

UPDATE 11/10/07

I feel the need for an update...
First off i'd like to say that the red celica is a pain in the ass, not to mention its cold as hell outside. I spent 250$ on parts to fix her, if she has any problems within the next decade, im gonna be pissed.

The alltrac is doing fine, though she was leaking oil for a week but then she just stopped.. weird, yes but i'll have to fix it eventually. Here are pics accordingly.






bitch car...

 

so true