my part finally came in, unfortunately its the water outlet for a 2.2 and not a 2.0 but it is close enough since i couldnt find one at all, nobody here seemed to have one and there wasnt one on ebay so i had to make this work. the bolt pattern was the same but there was issues with my heater hose hitting the dizzy cap and kinking off, same with the bypass hose, i put a foot of new hose on it and it still kinked. Im going to just install a T-splitter to where the bypass hooks up to the housing, then run one end to the heater and the other to the bypass and then just cap off the end by the dizzy and then problem solved. Luckily its pretty much summer time right now so i dont need the heater anyway so its fine the way it is at the moment, its not running hot or anything so its fine for now. All of my sensors fit in with one exception, i had to move one of them to a different location since it bottomed out where i needed it to go, so i drilled out the inside of the hole where the temp guage sensor went and swapped em out. I dont have any room on the housing for my vaccume switches, one for the egr and one for the evaporator canister, but i had already disconnected those anyway so they arent needed. the only other issue i had is the radiator spout sits at a downward angle now so i had to rotate my hose some to get it on there without kinking.