EGR Removed... than what...?

Discussion in 'All Motor Power' started by Edwin Pleijsier, Aug 3, 2007.

  1. Hey Ppl, Im new on this, but i removed my EGR entirely. My reason was that my engine was not running properly, and the EGR VSV was broken. so i dicided to remove it.
    The thing now is, after i placed two plates in place. The question is, what to do with the small tubes coming from down below... and other tubes...
    By the way, its about a 1988 St165...

    All help is welcome!
    Edwin
     
  2. underscore

    underscore Well-Known Member

    block them off...I think you can get little rubber nubs that go where the hose plugged in before. or just clamp them off.
     
  3. Youds

    Youds Well-Known Member

    ya i was told to just block all the egr lines (look at vacuum diagrahms) if u have tubes going still u didnt take it all out ;)
     
  4. thanks for the help, im going to block the one that comes from down below... but as far a i know, the two on top of the are to be conected by a tube, is this correct?

    Edwin
     
  5. slow_yota

    slow_yota Well-Known Member

    I'd buy a set of block off plates..much nicer looking
     

Share This Page