Separate names with a comma.
Beams engine swap into st162 The good news is that the engine angle, engine mounts... Transmission drive shafts... All match up. The bad thing...
So it seems I will have to custom order Pistons for the Beams turbo build. I have an extra set of wiseco 86.5 forged Pistons to go along with the...
Beams swap into GT4 chassis and drivetrain Hey Resto! There is a guy in Sweden who has created a monster gt4 by using the beams head with VVT-i...
Hey guys it's been a while since I have been on here. A lot has changed, moved to Florida, bought a Saab (been modding that too). I have an 88...
Wiring Hey turbonelson420, check out tweaked performance.com. I talked with them about my wiring options. I am also doing the st215 into an 88...
Thread update So I got in touch with tweaked performance tuning. They offer custom patch harnesses for all toyota 4-cylinder engines. They can...
Harness and ecu options Thanks for the reply sillyca. So you had the 3sge harness and ecu hooked up on your build and had over fueling. I was...
Suggestions for ecu... Hey guys, the build project is moving onto the next phase which is engine management. I m curious to know if the st162...
Thread update Hey Mafix, yeah stock cams. I would like to install aftermarket cams and likewise aftermarket ecu. I know there is a lot of...
Thread update... So the no start issue was due to no compression. Cylinder one was registering 60, about one third what it should be. I pulled...
[ATTACH][ATTACH] Here you can see the layout of everything. I didn't want to go over the turbo exhaust housing with the compressed air but because...
Crank and no start on build Ok, so here is where it sits... cranks, but won't start. I bridged diagnostic terminals to see what code it throws...
thread update So... FMIC is installed and piping is done. What a fun way to spend the afternoon. I have my MAF sensor in line right before the...