/ Register

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Thermo fan switch/Controller

Discussion in 'Electronics' started by dan1_721, Dec 22, 2007.

Page 2 of 2
  1. ST165-2765

    ST165-2765 Well-Known Member Donated!

    I knew there was something wrong with your thermostat.


    [​IMG]

    Okay lets do the test and make sure your temp sensor is working.

    Do test # 1 above. You don't really need to remove the sensor from the car. Just unplug it and make sure there is continuity between the sensor terminal and ground when the engine is cold. Next warm the engine up and then do the test again and you should no longer have continuity between the sensor terminal and ground.

    If the sensor tests ok then we'll check for continuity of the wire.
     
    ST165-2765, Jan 15, 2008
    #21
  2. dan1_721

    dan1_721 Guest

    Now i get to buy an Ohmeter.lol. Will do, and do the test.
     
    dan1_721, Jan 15, 2008
    #22
  3. dan1_721

    dan1_721 Guest

    So far only tested the fan switch. No continutity. The one that was on there before does have however, so when i can il put that back on and check the relays etc.
     
    dan1_721, Jan 17, 2008
    #23
Page 2 of 2

Share This Page

Welcome to our site! Please take a moment and Register today!