Separate names with a comma.
well then i hope he sends ya the pic so you can figure out what the issue is. meanwhile here is a pic of the center valve cover bolts from mine....
Probably something silly like him putting them on upside down or something. from what i saw they are the same as ours so if they dont fit it is...
here is a pic that clearly shows where the center bolt is located in the valve cover. Mine is the us version so his should look like mine here....
The coolant lines heat up the valve so it knows how much air to let in to control the engine idle. aftermarket parts huh... that could very well...
thats 1st generation. from what ive heard its not a good idea to turbo them cause of many factors like compression, rods not strong enough, no oil...
Oh ok, then probably just something with the wireing then, is the check engine light on? and double check your vaccume lines and make sure they...
:bounce Hey guys, havnt made much progress since i had to quit my job since it was killing my poor car. Anyway here is my situation. Every time i...
has it always been doing this or was it doing fine ill recently? the reason i ask is you could have simply somehow bent the bracket that the cable...
:drool:drool:drool:drool
maybe make some adjustments or some new brackets and move it closer toward the exhaust, should be a bit of room if you have the fans on the...
did you try e-mailing him?
just check a prats distributor, check the part number for a 3sge engine and then for a 3sfe. if the part numbers are the same for the starters for...
There ya go, glad you figured it out finally. by the way what is that engine out of?
nice, very clean engine there. Should be a sinch finding leaks on that thing lol
I was planning on yellow, with black accents and a stripe down the side with GT-S in it. Im very very tired of the blue.
im liking how the white primer looks as well, but then again im probably just liking it because it is fresh and clean paint rather than how the...
if there is oil on the inside of the distributor then the inner seal is likely bad, its a seal that prevents oil from traveling down the shaft as...
Whats illegal? I still have to remove my inner fenderwell and push my lower fender outwards so it lines up with the bottom of the door, you cant...
As i said, progress is slow going but i am making progress. Ever so slowly working my way around the car, fixing rust, patching holes, realigning...
Sweet car, Hey where did you find the snorkel thing on the back of your alternator? Ive been thinking about making something similar to help keep...