Separate names with a comma.
Location?
End of Summer Upgrade I spent the last few weeks upgrading a few key components: 1) Larger heat exchanger. 2) Larger IC pump 3) Heat wrap...
Push it to 1.1 :) Finally picked up a set of JDM corners. Needed some polishing so I polished and then wired it up. [img] [img] [img]...
Thanks guys! Manual boost controller stopped working. Picked up a Turbosmart EBoost Street and cranked her up to just under fuel cut for the...
I really haven't updated this since last year? Oops. Well here is like 7 months worth of updates: November 22nd 2015 So after burning...
October 10th, 2015 Stuff has arrived and stuff needs to be replaced. Removing the rear main seal. [img] New OEM seal. [img]...
Next time I have the cluster apart I'll take some pictures. All I did was dremel it out a bit to fit and used some hot glue to hold it in place...
If your not planning on massive power, I would just do the following: Timing belt Water Pump Cam Seals Oil pump pulley seal Front main seal...
Any 3S block will bolt in with your existing motor mount locations and everything else should mechanically fit. I believe you can use your...
Sadly no. It was a between the timing belt and the clutch due to funds. I gambled and lost so I'm paying for it now. Lightweight flywheel to go...
October 3rd, 2015 Preparing to drop the motor for the clutch replacement. Ordered a Clutchmasters Stage III FX300 clutch + ARP Flywheel bolts...
September 27th, 2015 Few things have changed since the last update but not a whole lot. Long story short, I should of replaced the clutch while...
IIRC it is 10 degrees BTDC.
If your fan came on with the key turned to ON, that means that the coolant temp sensor is either bad or unplugged as a safeguard. If you fan has...
Awww yish! August 29th, 2015 Another long time since I've updated but I've finally got everything dialed in and running. My first test run...
