Separate names with a comma.
I finally upgraded my gt/st axles to the gts units. A little background: 1987 GT coupe 1996 JDM 3sfe with 8 bolt crank 1996 camry s53 gear box...
I discovered that using 93 octane fuel really helps out a lot!; especially at full throttle. Full throttle works like never before; it pulls...
this has to be the coolest looking 4th gen i've ever seen!
I removed the EGR plug and installed the EGR just like it was on the old engine. also used new spark plugs with the correct gap. I've adjusted...
279000 mi 449006 km but the engine only has about 50000 mi/80467km
EGR goes to a port in the head. this engine had a threaded plug in that port
if you do keep it you will learn a lot. I know I did. low idle sounds like a vacuum leak, and the shaking sounds like worn out or broken motor...
I'm using the original USDM manifolds, injectors, and EGR. [IMG] whats this about my GE style ECU? I thought the GT in america was only FE and FE ECU
My car is a 1987 GT Coupe 3s-fe, manual transmission. The 3s-fe is a JDM unit from 1996. When I did this swap, I deleted the A/C and power...
Greenville. I was planning on getting a new system at some point. I would like to start with the headers though. That is a good point about...
Will these bolt up to the rest of my exhaust? OBX Racing Sports SS Exhaust Manifold Header 86-89 Toyota Celica GT 2.0L 3S-FE...
It was sitting in that particular celica, but i don't think it was original to that car because it doesn't fit perfectly.