Separate names with a comma.
I'll be dissecting carefully to see if I can pinpoint something, other than the expected tossed bearing that I think is the result, not the cause.
Okay, so I'm just trying to find an answer when there probably isn't one - except shit happens. I'm just hoping to figure out what I can do...
I haven't thread-searched this at all, so feel free to bash.... I've gone through 2 engines where I suddenly lost oil pressure and spun rod...
With that front air dam it must be very fast and aerodynamic....
According to wikipedia, this was the ninth generation T170 Corona, also known in Europe as the Carina II GT-R (sport model with 2000 cc (3SGE)...
Haven't had time and still unsure if I trust myself to not confuse my shotgun for the wrench... :? Maybe this coming weekend.
It's all good. I should have been more clear regarding the chronology of my posts/comments. I would be frustrated, too, if it appeared that...
Mafix is correct. The car has not moved or been started since the engine went out. I was attempting to make light of the situation by commenting...
On the up side, before the lower end went again, the idle speed (cold and warm) were perfect and very stable after replacing the IACV and TPS. To...
Probably does. It was on the short list for the crusher when I resurrected it.
So... I should plan on at least new main and rod bearing caps? Did I probably screw my new crankshaft, too? Maybe I should just start saving to...
SH*T! I just did a complete engine rebuild. Now this? Everything was done completely by the book (BGB). All new internals. Block and head decked,...
Well, the complete rebuild was doing just fine. I did the 500 mile oil change, along with a new TPS, O2 sensor, coolant temp sensor and coolant...
